Is there a similar set of pics and instructions for adjusting the AD truck
doors? (47- 54)
***********************************************************************
Jim Wilkerson
***********************************************************************
-----Original Message-----
From: Blaine & Maggie Dumkee [mailto:bmdumkee@auroranet.nt.ca]
Sent: Saturday, April 12, 2003 11:00 PM
To: SurfDudeSC@aol.com; oletrucks@autox.team.net
Subject: RE: [oletrucks] door ajustment/alignment question
Here is a post from Wayne Osborne from last fall. I hope it helps.
So here is there door alignment procedure from their catalog...
http://www.chevytrucks.org/temp/door_alignment.jpg
http://www.chevytrucks.org/temp/door_alignment1.jpg
http://www.chevytrucks.org/temp/door_alignment2.jpg
The alignment procedures comes straight from the shop manual... ---wayne
-----Original Message-----
From: owner-oletrucks@autox.team.net [mailto:owner-oletrucks@autox.team.net]On
Behalf Of SurfDudeSC@aol.com
Sent: Saturday, April 12, 2003 12:05 PM
To: oletrucks@autox.team.net
Subject: [oletrucks] door ajustment/alignment question
Hi group;
I'm having a problem getting the drivers side door, specifically the upper left
"corner" area near the cowl. Problem is I have the hinge holes adjusted all
the way "out" but the door "corner" will not come out far enough with the cab
to be flush. Furthermore, the front of the door edge strikes and binds on the
fender. Any suggestions would be appreciated. Thanks. David 57 GMC 1/2 ton
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|
