Thanks John,
Yup, that was it. I had the guage pretty much apart, but was expecting
(don't know why) for the whole pin to come out. Used two screwdrivers,
and it popped right of.
-Larry
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net] On Behalf Of JohnHuntD@aol.com
Sent: Thursday, July 24, 2003 8:07 AM
To: laburnett@earthlink.net; oletrucks@autox.team.net
Subject: Re: [oletrucks] Speedo needle replacement
Hi Larry,
I replaced the speedometer needle on my 1949 3600, and it is an easy
job. I
assume by now you have pulled the chrome rim and glass off the front of
the
speedometer by gently straightening the tabs on the rim that are bent
back over
the speedometer housing. The needle is held on the shaft by friction,
and to
remove it it is critical to pull on both sides simultaneously. I used
screwdrivers as levers 180 degrees apart on the base of the speedo
needles, using the
housing as the fulcrum to gently pry the needle off the shaft.
I installed the new needle with my thumb, making sure I was pressing
evenly
and gently on the new speedo needle center, and not putting pressure on
the
needle itself lest I snap it off.
Hope this helps. Good luck.
John Doak in Baltimore, MD
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|