Hi Ryan. Go to http://www.eastwoodco.com/ and search
for "dent puller."
Good luck.
Drew
--- Ryan Sain <rsain@gte.net> wrote:
> Well,
>
> Please look here:
>
> http://www.wsu.edu/~rsain/dingspots.jpg
>
> In this pic (not of my cab - but another list
> member's) I put some green
> dots where I have a few small radial type dents.
> Given that all these spots
> have a piece of sheet metal covering them on the
> opposite side of the cab -
> how the %$^# am I supposed to hammer them out? Or do
> I?
>
> Should I just cut a little section out of the metal
> on the inside so I have
> access then hammer away? Or should I simply fill em
> and forget em?
>
> None are bigger than .75" in diameter. The truck is
> a 59
>
> TIA,
>
> - Ryan
> oletrucks is devoted to Chevy and GM trucks built
> between 1941 and 1959
=====
Drew
http://www.norselander.com
////////////////////////////////////////////////////
__________________________________
Yahoo! SiteBuilder - Free, easy-to-use web site design software
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|
