[oletrucks] tranny repacement`

["Dennis Larson" <DLLarson1@frontiernet.net>]

THey make a little dummy tool to align the clutch and pressure plate up on the
flywheel after they have been slightly loosened. Or, you can make one out of a
piece of wood yourself or another trans input shaft.  Just need something that
will fit inside everythingfairly tightly.  move the pressureplate to the final
position, tighten the pressureplate back up and you should be good to go.

Dennis Larson
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959