oletrucks
[Top] [All Lists]

[oletrucks] Head Lamp Rim Seal Question

To: "Oletrucks" <oletrucks@autox.team.net>
Subject: [oletrucks] Head Lamp Rim Seal Question
From: "Mac Kinghorn" <kinghorn@granite.mb.ca>
Date: Thu, 23 Jun 2005 00:33:36 -0500
The rubber seal with the wire through the middle of it fits into the 
headlight rim at the edge were it seals around the retainer ring on the 
headlight bulb.  The seals may be a little on the long side and will 
probably have to be trimmed a little in length to get a perfect fit.  The 
wire does not need to be trimmed as the excess will fit up into the opening 
on the opposite side.  You will also need some wire spring clip retainers to 
install and hold the seal in place.  If you haven't got them you will need 
to order them as the seals will not stay in place without them.  They are, 
from my own experience , quite easy to install.

Take your time, think about what you are doing and good luck!!!

Mac
52 Chev 1300 

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959





<Prev in Thread] Current Thread [Next in Thread>
  • [oletrucks] Head Lamp Rim Seal Question, Mac Kinghorn <=