spridgets
[Top] [All Lists]

Re: U Joint Zerk 70 Midget

To: "Spridgets" <spridgets@autox.team.net>
Subject: Re: U Joint Zerk 70 Midget
Date: Thu, 13 Apr 2000 11:16:10 -0400
References: <a1.3d4e3d2.2626f9d1@cs.com>
I've seen the same ujoint with and without grease fittings, but
never checked to see if the internal passageways on the latter
were still in place from the center of the 'cross' to the 4
bearing chambers. If they are there it would be a no brainer to
drill and tap in a grease fitting.

Mike L.

----- Original Message -----
From <DLancer7676 at cs.com>
To: <dwramsey@worldnet.att.net>; <froggi@cdsnet.net>
Cc: <spridgets@autox.team.net>
Sent: April 13, 2000 6:22 AM
Subject: Re: U Joint Zerk 70 Midget


> In a message dated 4/13/2000 12:38:04 AM Eastern Daylight Time,
> dwramsey@worldnet.att.net writes:
>
> << also of the non-greaseable,
>  non-replaceable kind.  >>
>
> On the non-zerk u-joints, is there any way to drill and tap a
zerk into them
> so one might make them greasable?
>
> ==David C.
>



<Prev in Thread] Current Thread [Next in Thread>