spridgets
[Top] [All Lists]

Re: Heater Valve studs

To: "Bryan Vandiver" <Bryan.Vandiver@Eng.Sun.COM>, <spridgets@autox.team.net>
Subject: Re: Heater Valve studs
Date: Thu, 20 Jul 2000 23:49:29 -0000charset="iso-8859-1"
References: <200007201808.LAA26496@shorter.eng.sun.com>
ummmm heater controll valve studs are 1/4"  i just can not remember if they
are coarse or fine threads.

chuck
the other chuck...  :)  i'm leaning towards coarse if i can remember at this
point?  been sanding car since 6:30 and it's 12:39 (getting a bit blearey
eyed) acording to mickey's hands and have a few hours to go before i shoot
it in primer.  have a bit of outpatient surgery tomorrow am(oh geez! i mean
later this morning!eeeeek!) and am going to be a bit tender.  figured that
primer can sit and seriously dry over weekend and then.....monday i'm a
screaming and a hurting or not i'll be out there doing the glaze , sand anr
reprime  routine!  gotta finish this car!  (read that pay the
bills!).....................   :)
----- Original Message -----
From Bryan Vandiver <Bryan.Vandiver at Eng.Sun.COM>
To: <spridgets@autox.team.net>; <chuckc@attglobal.net>
Sent: Thursday, July 20, 2000 6:08 PM
Subject: Re: Heater Valve studs


> Chuck,
>
> if you are not an orginality freak, you can just use standard grade 5
bolts,
> from a local HW store. I can't remember the exact size, but it's either
3/8ths
> or 7/16ths.
>
>  - Bryan
>
> >X-Accept-Language: en
> >MIME-Version: 1.0
> >To: spridget list <spridgets@autox.team.net>
> >Subject: Heater Valve studs
> >
> >Anybody know, offhand, what are the thread sizes of
> >the studs that mount the heater valve to the head on
> >a 1275?
> >
> >thanks,
> >
> >chuck
> >
>
>


<Prev in Thread] Current Thread [Next in Thread>