"Hanna, Mark" wrote:
>
> When finished , My Sprite will have wire wheels. I would rather not pound on
> the new UNDO's. It's bad for wheel bearings and the new knock-off spinners.
> I saw a plywood tool that fits the external shape of the spinner to save
> the chrome from being pounded on. I can easily build a tool to link my 100
> ft/lb. torque wrench to this plywood piece. If I build this tool each
> spinner will be tightened to the same value. the question is : What is the
> correct torque ?
I can tell you which plywood to use but I can't help with the torque.
I do have a question though, wouldn't the torque reading be different if
you have the wrench attached to a lever of wood?
Sot of like the reverse of a cheater bar on a wrench.
Oh BTW, use at least a 5 ply fir plywood, 3/4 AC would be best
--
Frank Clarici
Toms River, NJ
Too Many Sprites Again
|