maybe sandblasting up through the grommet and then vacuuming it out, or
sometimes the local junk store has wire bristle test tube shaped brushes..or..
fill the area with marbles/old ball bearings or something like that and drive
down a REALLY bumpy,curvy road..
after your done, oil spray up into the cavity.
what the heck..
R(wnik)Kansa/RCCSA
I just discovered a mystery (to me) area in my car that is at the bottom of
the footwell where the angled sheet metal is welded on. I hope this
description makes sense! When I pulled out the rubber grommet that is on
the under side furthest forward, lots of nasty black dirt came out onto my
drive way. Since I9m concerned about all this dirt initiating or causing
additional rust, I9d like to clean it out some way. Is there a good way of
doing this?
Thanks again,
Mike Gagne
74 midge
|