I have experienced the same problem with my sprite. I have a 948 with the
rib case trans. I noticed when putting the unit together that the 948
release bearing verses the 1275 release bearing has a different offset. So
thinking since I'm using a rib case trans I would us the 1275 release
bearing. Unfortunately, I am having the same condition as described by Greg.
Not sure what to do next.
Al
> ----- Original Message -----
> From: "Greg Higgins" <higgs@cgocable.net>
> To: <spridgets@autox.team.net>
> Sent: Saturday, June 08, 2002 12:05 PM
> Subject: rock hard clutch pedal
>
>
> > Listers
> >
> > I had the engine out of my 1098 sprite for some repairs. I put a new
> clutch
> > disc and throw out being in for good measure.
> > I bled the slave, the pedal goes halfway to the floor and then stops.
> > I have tried some adjustments at the master cylinder with out much luck.
> > My thought is, maybe the clutch disc is binding on the spines of the
input
> > shaft??
> > Any ideas
> > Thanks
> > Greg Higgins
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|