[Top] [All Lists]

Re: Powder coated header question / concern

To: Ankitterer@aol.com, denadave@attbi.com, spridgets@autox.team.net
Subject: Re: Powder coated header question / concern
Date: Sat, 11 Jan 2003 07:13:21 EST
In a message dated 1/10/03 10:00:53 PM Eastern Standard Time, 
Ankitterer@aol.com writes: 
> you can get a sanding block and sand it off.  Use a good emery paper 
> rather than regular "sandpaper."

And use a long sanding block that spans the width of the header so you can be 
sure to sand it all evenly.  Less likely to develop a leak if the whole 
affair is true.  Another way would be to rubber cement the emory paper to 
your flat workbench top or tack it over a board and rub the header over that 
to keep it true.

--David C.

--David C.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets

<Prev in Thread] Current Thread [Next in Thread>