My flat-top pistons finally arrived yesterday!
Quick question - I'm planning on checking the ring end gaps in the bores before
assembling the rings into the bores. I'm assuming everything'll be OK, but
should I have to remove a small amount of material, what's the best way to go
about it? is squareness of the end important?
TIA
-=Chris
Chris King - cbking@alum.rpi.edu
http://mywebpages.comcast.net/kvcbk/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|