I need to clean the threads on the rear end to which the nut that holds
the wheel bearing in place attaches. Is there a recommended tool? It
is the drivers side, so it is reverse threaded. In about 2 or 3
threads, it looks ok. I have ordered a new nut which was at least half
the problem, but the first couple of threads look kinda bad, and it is a
sorta important nut to not have fall off.
Thanks,
Dan
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|