I would wait for the new nut, lazy sod that I am.
--
Jay Shaffer
On Wednesday, June 18, 2003, at 11:44 AM, Dan Mullis wrote:
> I need to clean the threads on the rear end to which the nut that holds
> the wheel bearing in place attaches. Is there a recommended tool? It
> is the drivers side, so it is reverse threaded. In about 2 or 3
> threads, it looks ok. I have ordered a new nut which was at least half
> the problem, but the first couple of threads look kinda bad, and it is
> a
> sorta important nut to not have fall off.
>
> Thanks,
> Dan
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|