I have the guts of three Midget distributors lying on my table. Two of the
three guts are different. Only one has a working vacuum advance, but that one
has a 1/8" hole punched out of the side. I will make one out of the best of
1. Am I better off to patch the hole with epoxy, or move the vacuum advance to
another body? If I move it, how do I get it reset properly?
2. I have a 13 degree centrifugal advance with weaker springs and an 18 degree
advance with stronger springs. Which is better and why?
3. The manual says I should have a maximum advance in the mid 20 degrees. Why
are these marked less?
Long Island, NY
Support Team.Net http://www.team.net/donate.html