You can simply use a piece of 1/2 inch diam. inner hole heater hose or fuel
line. Make it a tiny bit shorter than the space where it will be and kink it
in the middle while putting it on. You should not have to remove much of
anything.
Mike C
-----Original Message-----
>From: James Lempe <oldtimealaskan@yahoo.com>
>Sent: Jun 25, 2008 6:36 AM
>To: Spridgets@autox.team.net
>Subject: [Spridgets] ByPass Hose
>
>I'm faced with the task or replacing a leaking water bypass hose on my BE.
>It's a small hose about 2" long that goes between the water pump and the front
>end on the head. Has anyone done this? Do I need to remove the water pump or
>is there some easy way to replace it?
>
>Thanks for the help!
>
>Jim in Homer Alaska
>
>---
________________________________________
PeoplePC Online
A better way to Internet
http://www.peoplepc.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|