I think I used a die grinder. No problems.
----- Original Message -----
From: "Michael Rowe" <mdrowe@optonline.net>
> Those of you with Rivergate conversion kits:
>
> How did you remove the contact plate from the fingers of the clutch pressure
>plate as required to use a roller-type throw-out
> bearing?
>
> Michael Rowe
> Aspiring engine builder
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|