Kirk,
While examining the remains is there any indication that the T.O. bearing may
not be running concentric with the clutch ? I am thinking about a potential
misalignment of the fork. I've seen several bent forks and had to compare them
to know what was correct. A smooth case fork has the pivot shifted so that the
bearing would be off center, but I don't know if it could be installed in a
rib case trans. Just thinking out loud.
John
Fogelsville, PA
--- On Thu, 7/14/11, Kirk Hargreaves <khargreaves2@gmail.com> wrote:
From: Kirk Hargreaves <khargreaves2@gmail.com>
Subject: [Spridgets] T Bearing - 59 Sprite
To: spridgets@autox.team.net
Date:
Thursday, July 14, 2011, 1:32 PM
Once again my T Bearing has burned out. This time after a good year of
driving the car around town. This is my turd T Bearing to fall apart before
it's time . . and yes I have checked the rod length on my slave cyl per
measurements that Frank gave me a long while ago. I am going to check it
again just in case I did not cut it short enough. . but think it should be
right on and not the problem.
I am wondering who sells a good quality bearing type throwout bearing
instead of going back to the carbon type unit? I am using a Rib Case.
Thanks,
Kirk
59 1275
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/fastvee@yahoo.com
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|