tigers
[Top] [All Lists]

Re: Engine mount spacers

To: "Rose, Mark G" <mrose@ou.edu>
Subject: Re: Engine mount spacers
From: Steve Laifman <SLaifman@SoCal.RR.com>
Date: Tue, 11 Sep 2001 18:03:13 -0700
"Rose, Mark G" wrote:
> 
> Steve-
> 
> I was reading your email to Chris a few weeks ago and you mentioned "the
> original thick washer spacers between the motor mount and the block"
> 
> What do the washers look like. I'm rebuilding my father-in-laws car and they
> might be in a box somewhere. If I can't find them, what thickness were they?
> 
> I appreciate your help.
> Mark
> B382000974

Mark,

Since I put them back on, I will have to get under the car to measure,
but my "Quesstimate" would be about as thick as a quarter.

I do have the original mounts, and an impression of the washer is still
on the steel that faces the two block threaded holes.

My measurements of it's "shadow" are 7/8 in. OD, with a center hole to
fit the bolt. The hole in the mount is 9/16 ths.

This cleared my trimmed fan, before they were left out.

Steve
--
Steve Laifman        < Find out what is most    >
B9472289              < important in your life     >
                               < and don't let it get away!>
<SLaifman@SoCal.RR.com>
<http://www.TigersUnited.com/gallery/SteveLaifman.asp>

_/_/_/_/_/_/_/
     _/                 _/_/_/       _/_/_/       _/
    _/        _/      _/     _/     _/    _/     _/_/_/_/
   _/        _/       _/    _/      _/  _/      _/
  _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
                          _/
                     _/_/_/

<Prev in Thread] Current Thread [Next in Thread>
  • Re: Engine mount spacers, Steve Laifman <=