If you have screws in the frames check that they don't hit the glass. A lot
I've seen with plex have the screws going against the plex. A NO NO with
glass. Grind them down or get shorter ones.
In a message dated 3/2/2009 11:41:56 A.M. Pacific Standard Time,
garywinblad@comcast.net writes:
Hi Jim,
I replaced mine with Tom Hall/STOA glass in the 1975-1979
timeframe but they still look great...
IIRC, all I did was drill out the old rivets, change the glass and
then re-pop-rivet it. I just went out and looked at them, I see
I could not do the underside one closest the rear corner.
Only one rivet there but I have never had a problem and you
have to look underneath to see it ;-)
Gary
----- Original Message -----
From: Rollright@aol.com
To: tigers@Autox.Team.Net
Sent: Mon, 2 Mar 2009 19:18:46 +0000 (UTC)
Subject: [Tigers] quarter window replacement help request
Hello,
This was buried in a letter to the list serve I wrote end of last week.
Didn't hear from anyone so I'll try again.
QUESTION: We are replacing the hardtop quarter windows with the glass
ones
from the
fellow in CA. The task of removing the old and reassembly seems a bit
daunting. Those rivets. If anyone has done this before and can contribute
a process, I would be much in your debt.
Best regards,
Jim Armstrong
Mk 1A 382002083
LRXFE
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
**************Worried about job security? Check out the 5 safest jobs in a
recession.
(http://jobs.aol.com/gallery/growing-job-industries?ncid=emlcntuscare00000002)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|