That's the one I used. The Moss header gasket is pretty much the same.
Peter
on 5/3/03 6:29 PM, David Friedlander at forzion@maine.rr.com wrote:
> When I get my Rimmer 6-into-one stainless header back from Jet Hot,
> I plan on using the SLP193 header gasket I got from TRF. I've no
> idea if that's a "beefed-up" enough gasket .... Anyone know a better
> part number and source for a no-leaks header gasket, before I bolt this
> one together?
>
> Dave Friedlander
> CF25194UO
>
>
> Peter Macholdt wrote:
>
>> Gene,
>>
>> Did you use a heavy duty header gasket? I'm not sure that it is possible to
>> get a good seal without a beefed-up gasket. That's what I used on my Rimmer
>> header and, no leaks.
>>
>> Peter
>> '68 TR250
>>
>> on 5/3/03 5:47 PM, Gene Holtzclaw at motrv8d@hotmail.com wrote:
>>
>>> I've just put a header on from Rimmer Bros. It is the stainless 2 piece 3 to
>>> 1 headers. They leak at the head. Any suggestions from those who've been
>>> there done that?
>>>
>>>
>>>
>>>
>>>
>>> _________________________________________________________________
>>> Add photos to your messages with MSN 8. Get 2 months FREE*.
|