6pack
[Top] [All Lists]

Re: Oil Capacity

To: 6pack@autox.team.net
Subject: Re: Oil Capacity
From: Timothy Holbrook <tjh173@yahoo.com>
Date: Mon, 4 Aug 2003 17:56:35 -0700 (PDT)
Aaron,

Are you saying you put in 5 quarts, including a filter change?  I
believe the capacity is closer to 6 quarts.  This extra quart should
bring your oil level up to the top line on the dipstick.

Tim Holbrook
1971 TR6

--- Acekraut11@aol.com wrote:
> Hi List:
> This question is being asked under the heading of no question is a
> dumb question.  I changed the oil today for the first time since
> replacing the felt on the oil dipstick.  Now I am unsure if I have
> overfilled the oil or not.  I have put in 5 quarts and I believe the
> correct amount is 4.5 quarts.  Having said that, the oil level on the
> dipstick is about a quarter inch above the first line.  I had assumed
> that the first line on the dipstick was the low oil level, and the
> second the high oil level.  Is this the case or am I assuming
> incorrectly?  I have always filled vehicles in the past up to the
> high mark on the dipstick.  I did not check to see what the oil level
> would read without the felt, but I did check the felt and it appears
> it is seated in the dipstick tightly.  I seem to recall the oil level
> before the oil change to have been close to the second mark, but it
> wasnt something that I was paying close attention to, having checked
> the oil level periodically and found it !
> to be ok.  The car does have a spin on oil adapter, but does not have
> either a rocker feed, or an oil cooler.  And, yes, I did check for
> oil leaks and there are none.(other than the typical Triumph marking
> its spot.)
> Thanks for your assistance.
> Aaron Cropley71 TR6


__________________________________
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com

///  6pack@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>