6pack
[Top] [All Lists]

Re: Stock Thrust Washer Thickness

To: "Robert M. Lang" <lang@isis.mit.edu>
Subject: Re: Stock Thrust Washer Thickness
From: Todd Bermudez <red_tr250@yahoo.com>
Date: Tue, 10 Jan 2006 07:50:25 -0800 (PST)
Yeah, you're right, shim is the wrong word....bad
Toad, bad Toad...I knew what I meant

So do we know the thickness of the stock washer?

Todd



--- "Robert M. Lang" <lang@isis.mit.edu> wrote:

> On Tue, 10 Jan 2006, Todd Bermudez wrote:
> 
> > All,
> > 
> > Got a call from a local guy that just happens to
> know
> > that I have internet access at work...he did not
> > 
> > Apparently the machine shop called him looking for
> the
> > thickness of the stock thrust washer.  Anyone out
> > there with that figure buried in their head?  Or
> > perhaps you know where it is in the book?  Or
> there's
> > another way of determining if you need shims?
> 
> Shims???
> 
> The t/w's are sold in STD, +.005, +.010, +.020 and
> +.030
> 
> You mix/match the thrust washers to get the proper
> end-float.
> 
> You def. do not want shims between the t/w's and the
> block.
> 
> > Cheers,
> > 
> > Todd Bermudez
> > CD198L
> > CF25768UO
> 
> regards,
> rml
>
------------------------------------------------------------------------------
> Bob Lang              Room N42-140Q            | 
> This space for rent
> Consultant            MIT unix-linux-help      |
> Voice:617-253-7438    FAX: 617-258-9535        | 
> Cell: xxx-xxx-xxxx
>
------------------------------------------------------------------------------
> 
> 



                
__________________________________________ 
Yahoo! DSL  Something to write home about. 
Just $16.99/mo. or less. 
dsl.yahoo.com 




<Prev in Thread] Current Thread [Next in Thread>