Re: [6pack] Weber DCOE fuel inlet parts

["Navarrette, Vance" <vance.navarrette@intel.com>]

        Try here:


        http://www.metricmcc.com/catalog/Ch2/2-250.pdf

        15.2mm available off the shelf. Is that good enough?

        Vance


-----Original Message-----
From: 6pack-bounces+vance.navarrette=intel.com@autox.team.net
[mailto:6pack-bounces+vance.navarrette=intel.com@autox.team.net] On
Behalf Of Chuck Arnold
Sent: Monday, February 25, 2008 10:45 AM
To: Friends; Triumph; Triumph Email List
Subject: [6pack] Weber DCOE fuel inlet parts

I have a set of triple Weber DCOEs.  The fiber/cotton?? washers
surrounding
the banjo bolts on the fuel inlets have deteriorated to the point they
leak.  I cannot find replacement parts.  The outer one is 15mm, but
crush
washers come only in14 [too small] and 16 [too big].  The Carb supplier
I
usually use says they are not available.  Does any one have a source?

--
Chuck Arnold
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive