All,
Put disk in backwards in a TR3 once. Trans went back in fine but clutch
wouldn't disengage. Splined shaft holder (technical term) on the disk is
offset, long protrusion goes toward the transmission. If not it sort of drags
on the flywheel and doesn't disengage so well. We were trying for the record
replacing TR clutches back in 1963. Did it in 37 minutes, now if the disk had
just been in the proper direction...
Bill
'70 6 one owner
----- Original Message -----
From: Dale <tpdwinch@yahoo.com>
Date: Friday, June 25, 2010 7:48 am
Subject: Re: [6pack] tranny problem
To: "Navarrette, Vance" <vance.navarrette@intel.com>, oliver
<sumton@sbcglobal.net>, Triumph 6 Pack <6pack@autox.team.net>
> Oliver
>
> Just by chance, are you sure that the clutch disc was put in
> correctly. The disc has on it flywheel side and trans side.
>
> Having this in
> backwards will leave you short of correct mounting. Dale
> ________________________________
>wright.edu
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|