Check your valve lash. When heated up the valve clearance decreases. Try
pulling off one spark plug wire at a time to see which cylinder is the
problem.
If you find that wither the two front or two rears are affected, it is
probably a carb problem.
Good luck.
Peace,
Pat
- Support Habitat for Humanity, A "hand up", not a "hand out" -
Pat Horne, Network Manager, Shop Supervisor/Future planner, CS Dept,
University of Texas, 1 University Station C0500,Austin, Tx. 78712-1188 USA
voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
On Wed, 2 Jul 2003 BARTERDUDE@aol.com wrote:
> Just put together a 1600 motor with domed pistons and when it first starts,
> it runs smooth and great, but when it warms up it acts like one cylinder is
> dead. Any ideas on what to check or adjust would be greatly appreciated.
>
> Gary Lasater - Parker CO
> 303 840 7172 ext 1
> founding member of <A HREF="www.WYCROC.org">www.WYCROC.org</A>
> [Unable to display image]
> 1963 SPL310-00289B (single carb earliest one of the group)
> 1969 SRL311-12536 (licensed as a '70)
> 1970 SPL311-28169 (one of the last of the group)
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|