[Top] [All Lists]

Re: [FOT] Quick-release steering hub for TRs

To: "SHANE Ingate" <>,
Subject: Re: [FOT] Quick-release steering hub for TRs
From: "Jack W. Drews" <>
Date: Tue, 14 Feb 2006 17:22:49 -0600
I have one in my car. It's not a big problem to put it in. I cut the 
taper and threads off of my steering shaft to weld on the quick 
release part. I also shortened the tube surrounding the shaft.

I installed one that has the hex-shaped part for the steering column. 
If I had it to do again, I'd get the kind that has a lot of little 
splines. the only problem I have with the hex is that you must mark 
everything very carefully so the steering wheel always goes on straight.

At 03:41 PM 2/14/2006, SHANE Ingate wrote:
>Hi Gang,
>Anyone ever mounted a quick-release steering hub to the
>stock TR steering column?  Any tips, hints to make it work?
>These bones and joints are not getting any younger, and getting
>in/out of the car with the surrey top and roll-cage is hard work.
>Note to self: Put helmet on when IN car.
>Shane Ingate in Maryland

uncle jack 

No Virus Found In This Message
Scanned at

===  unsubscribe/change address requests to

<Prev in Thread] Current Thread [Next in Thread>