fot
[Top] [All Lists]

Re: [Fot] Recalcentrant Bolt!!!

To: <BillDentin@aol.com>, <billb@bnj.com>, <hottr6@hotmail.com>
Subject: Re: [Fot] Recalcentrant Bolt!!!
From: "Tim Murphy" <timmurph@fastbytes.com>
Date: Mon, 26 Mar 2007 14:39:44 -0500
The Mechanical Engineer's mantra!!  Except when it's a left hand thread like 
on water pump pulley we once had to remove.  The manual was a little 
"unclear", to say the least.  We had it on there pretty tight before we got 
it off.

Tim
----- Original Message ----- 
From: <BillDentin@aol.com>
To: <billb@bnj.com>; <hottr6@hotmail.com>
Cc: <fot@autox.team.net>
Sent: Monday, March 26, 2007 11:49 AM
Subject: Re: [Fot] Recalcentrant Bolt!!!


> In a message dated 03/26/2007 10:32:57 AM Central Standard Time,
> billb@bnj.com writes:
>
>
>> It would be a pretty big or specialized shop to have EDM stuff. It's
>> a nut. It will come off. If worse comes to worst, use a chisel
>> against the edge of the flats. It helps if you make a nick with a
>> sharp chisel and then use a dull one to apply torque. Big Big F*&%
>> $ing Hammer (BBFH) and a bit of technique. Just be sure you're
>> loosening the nut, not tightening it.
>>
>
> 'Righty Tighty...Lefty Loosey"
>
> Bill (Damdinger)
>
>
>
> **************************************
> AOL now offers free email to everyone.
> Find out more about what's free from AOL at http://www.aol.com.
> _______________________________________________
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>