Kas and I have been discussing some issues that I'm experiencing with the
GT6 intake and header.
After looking at a friends Spit with a PRI header which has this huge plate
to bolt to the head,
I am wondering if I should try and design a "sandwich" plate to mate up to
the intake and header?
If it was done right and thick enough, I figure it would provide a means to
ensure even pressure across the various pieces.
As Kas just told me, the head was designed by a tractor guy!
Its a cold rainy day in Ottawa. So as my driving season is all but done, I
need something to day dream about.
Andre Rousseau - firstname.lastname@example.org
'68 Triumph GT6 MK1 - http://www.gt6.ca/
Ottawa, ON, Canada
Support Team.Net http://www.team.net/donate.html
Fot mailing list