You can do if you have an light weight flywheel. With the stock flywheel you
only get the bearing cap out if you have removed the outer edges of the
sealing ring.
Chris
-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von Bill Babcock
Gesendet: Dienstag, 11. November 2008 04:22
An: J.C. Hassall
Cc: fot@autox.team.net
Betreff: Re: [Fot] TR4 rear main seal
I don't think so. you can pull the center main with the engine in
place, but I've never figured out a way to pull the seal or the rear
main without pulling the engine.
On Nov 10, 2008, at 5:10 PM, J.C. Hassall wrote:
> I need to change the main bearings in my TR4. The engine is in the
> car with the gearbox attached. Is it possible to pull the rear main
> cap? I'm specifically concerned about the seal - I have the new
> split-type seal. I took lots of pix of the engine as I assembled it
> *except* the split seal and associated bits.
>
> TIA
>
> jim
>
> --
> J.C. Hassall
> Blacksburg VA
> '63 TR4 in autox preparation
> 96% finished, 90% to go
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
Bill Babcock
Babcock & Jenkins
Billb@bnj.com
503.936.7660
www.bnj.com
Editor
Ke Nalu e-Magazine
Paddlesurfing's Web Journal
Bill@kenalu.com
www.kenalu.com
blog: www.ponohouse.com/ponoblog
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|