[Fot] Detroit Locker

[Dennis DeLap <yellow-green@sbcglobal.net>]

Friends - especially those of you who are machinists or know a good one.  
I have an old locking differential carrier that I would like to use in a 
Triumph powered car that I am building.  The problem is: the side bearings have 
been taken on and off so many times that one side is worn to the point that it 
no longer holds the bearing tight. What can be done to get these bearing 
surfaces built back up to spec?

Any ideas?
Dennis DeLap

_______________________________________________

Support Team.Net http://www.team.net/donate.html

http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot