fot
[Top] [All Lists]

Re: [Fot] 89 mm liners in a street TR4

To: "Tim Murphy" <timmurph@fastbytes.com>
Subject: Re: [Fot] 89 mm liners in a street TR4
From: Bill Babcock <billb@bnj.com>
Date: Thu, 11 Feb 2010 17:55:22 -1000
I don't think so. I've only used them in racing applications though. I'd
probably leave the compression ratio at 9.5 so you can get by with pump gas.

On Feb 11, 2010, at 5:23 PM, Tim Murphy wrote:

> I'm planning on rebuilding the engine in Ryan's street 1964 TR4.  We're
> thinking of putting a set of Ken Gilanders liners and forged pistons in.
Is
> there any downside to using the 89 mm liners versus the 86 or 87 mm liners?
> If the 89 mm liners are used is there anything else that would have to be
> changed?  The car has the Stromberg carbs and he has already put a 4 into 1
> header on it some time ago.  Had to, the cast iron exhaust manifold cracked
> in half.  We've already gotten one of Larry Young's 270 cams for it and
plan
> to mill the head slightly.  The 89 mm liners would bump the CR up to 9.5
> with the stock head and I was thinking of milling it to go to 10 to 1.  I'd
> appreciate any thoughts/advice from the group on this.
>
>
>
> Thanks,
>
> Tim
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $12.96
>
> You are subscribed as billb@bnj.com
>
> http://www.fot-racing.com
>
>
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> Brought to you by Team.Net consulting - Unix software specialist.
_______________________________________________

Support Team.Net http://www.team.net/donate.html

Suggested annual donation $12.96


http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

Brought to you by Team.Net consulting - Unix software specialist.

<Prev in Thread] Current Thread [Next in Thread>