The connectors look like new.
I inspect them when I put the engine back together, I just wanted to make
sure in advance that I didn't do anything wrong with them or if anything is
Von: Tony Drews [mailto:email@example.com]
Gesendet: Mittwoch, 31. Dezember 2014 15:17
An: MadMarx; firstname.lastname@example.org
Betreff: Re: [Fot] Aluminum connectors
No seal needed on the taper / AN joint. Normally are good sealing nicely
reusable fittings. But they are aluminum and if the sealing surface gets
damaged would need to be replaced.
Cheers, Tony Drews
At 05:44 AM 12/31/2014, MadMarx wrote:
>Hi @ all,
>hope you are getting well to the next year.
>My car has many oil lines and also a lot of aluminum connectors and
>some of the them do leak.
>Is there any trick to seal them?
>I think that I have tighten them enough and hesitate to tighten more
>not to destroy them.
>Is there a seal missing in those connectors?
>Just an example what I mean for the system.