Run a nut or die on the bolt, grind it to the right length, run the nut off and
it should be square. Be sure to keep it quenched with water or oil to keep it
cool and go slowly when grinding. Avoid too much heat.
Cheers, Bill
----- Original Message -----
From: timmmurphh--- via Fot
To: 'STEPHEN BOROWSKI' ; fot at autox.team.net
Sent: Sunday, June 04, 2017 2:58 PM
Subject: Re: [Fot] TR4 ARP Flywheel Bolts Question
FWIW
I just got a set of ARP 206-2802 flywheel bolts from Pegasus for the TR4.
They are for ?BMC A series?. The instruction specifically says, ?DO NOT USE
ANY WAHERS?, yes, all in caps for emphasis! They further state that ARP will
not be responsible for failures is washers are used. The instructions also
say, ?Make sure there is an adequate chamfer under the bolt holes on the
flywheel to clear the radius under the head of the bolt.? Torque is 55 Ft-Lb
with specified lubricants on the threads.
I?ve never had that much good luck grinding the ends of bolts and still
having it square so as not to start it cocked and runing the female threads.
Maybe it?s just me?
Tim
From: Fot [mailto:fot-bounces at autox.team.net] On Behalf Of STEPHEN
BOROWSKI via Fot
Sent: Friday, June 2, 2017 3:28 PM
To: FOT List <fot at autox.team.net>
Subject: [Fot] TR4 ARP Flywheel Bolts Question
Does anyone have experience using the ARP flywheel bolts sold by Moss and
others?
I understand that you may have to shorten the bolt or it breaks the rear
seal???
Are they supposed to have a washer or not?
Thxs. Steve
------------------------------------------------------------------------------
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/william.tobin31
at verizon.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20170604/b2c3817f/attachment.html>
|