fot
[Top] [All Lists]

[Healeys] Generator pulley dimensions

Subject: [Healeys] Generator pulley dimensions
From: coudesluijs at chello.nl (Oudesluys)
Date: Sun, 11 Jun 2017 10:19:27 +0200
References: <2164CB24AAE84D22B1E0E0813ADC4EC0@MarkPC>
If you are not racing and using the top revs of the engine most of the 
time, use the smaller pulley to have the advantage of a 10% higher 
generator speed thus a slightly higher charging.
Kees Oudesluijs


Op 11-6-2017 om 4:21 schreef Mark Donaldson:
>
> Listers,
>
> Until now I'd never noticed the small differences in generator pulley 
> diameters.
>
> What is the diameter of the pulley fitted to a Mk II tri-carb - part 
> number AEC 910 ?
>
> The one presently fitted to mine is 100mm.  It does not have a part 
> number on it.
>
> I have a 100/6 pulley with part number AEC 291 sitting on my shelf.
>
> It shows the part number on the casting and has a diameter of 110 mm.  
> (see photo attached.)
>
> As a matter of interest - could the 100/6 pulley be used on a later 
> model without adverse effect - bearing in mind the generator speed 
> would be only marginally reduced.
>
> Mark
>
> Ardmore
>
> NZ
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs 
> at chello.nl
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20170611/f95e7977/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>