The last set of Bumblebee wires I used had theO- rings.
John Sims, BN6
Aberdeen, NJ
www.healey6.com
-----Original Message-----
From: owner-healeys@autox.team.net [mailto:owner-healeys@autox.team.net] On
Behalf Of Michael Salter
Sent: Wednesday, November 15, 2006 3:26 PM
To: 'Bob Johnson'; 'Healeys'
Subject: RE: Ignition cable lenghts
Hi Bob,
Originally six cylinder Healeys used a rather heavy section O ring, with an
OD of about one inch to hold #s 5 & 6 and 1 & 2 ignition wires together
about halfway along their length.
The part number for the O ring was 2H35.
I presume that this was intended to prevent the longer cables from drooping
down and shorting out on the engine itself.
Michael Salter
www.precisionsportscar.com
-----Original Message-----
From: owner-healeys@autox.team.net [mailto:owner-healeys@autox.team.net] On
Behalf Of Bob Johnson
Sent: Wednesday, November 15, 2006 2:29 PM
To: Healeys
Subject: Re: Ignition cable lenghts
Tell me more about these o-rings. I've never seen these. Am I missing
something significant here?
Thanks,
Bob Johnson
BJ8
>
> O-rings on 1&2 and 5&6 wires.
|