Scott,
Check the end of the master cylinder pushrod where it links to the clutch
pedal. When I replaced my master cylinder, I found that the hole for the
clevis pin had become a slot. I was loosing almost 1/2" of travel.
Peter Schauss
1963 BJ7
1980 MGB
> -----Original Message-----
> From: healeys-bounces+schauss=worldnet.att.net@autox.team.net
> [mailto:healeys-bounces+schauss=worldnet.att.net@autox.team.net] On Behalf
> Of Scott J Graham
> Sent: Sunday, October 07, 2007 7:57 AM
> To: healeys@autox.team.net
> Subject: [Healeys] GEARBOX / HYDRAULICS - WHICH IS IT?
>
> The box in my BJ7 is crunching slightly in each of the gears when hot.
> The
> clutch feels spongy underfoot. The o/d was out recently and the clutch was
> checked and is in good nick. I had the clutch bled this week which has
> improved feel a bit and reduced the crunching a little. I was told that
> the
> issue may be the master or slave cylinder on their way out. What thinks
> the
> group? I need to get this sorted as I will be running in the local Alpine
> Rally this coming weekend and do not want to drive it if clutch issues are
> gradually ruining the gearbox.
>
>
>
> Scott Graham
>
> BJ7 Schappelle
>
> Sydney Australia
>
>
> Version: 7.5.488 / Virus Database: 269.14.3/1054 - Release Date: 6/10/2007
> 7:12 PM
> _______________________________________________
> schauss@worldnet.att.net
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|