On my BN1 I inserted the bolt through the tab from the front before I
reclocked the starter. With the starter reclocked the bolt is loosely
captured when you install the starter. The nut/washer ends up on the aft
side of the bellhousing but I wont tell anyone if you don't.
Marv J
On Tue, Feb 3, 2009 at 6:56 PM, Jorge Garcia <fortee9er@yahoo.com> wrote:
> I spent the afternoon tinkering with the starter and got it clocked so that
> it cleared the passenger toe box and the engine block. The top bolt no
> problem but the bottom bolt not so good there is very little room for the
> nut to fit between the starter motor and and the mounting tab. I should
> clarify that the nut will just fit but not the nut and the lock washer. I am
> thinking of finding a thinner nut that will fit with the lock washer. Any
> ideas suggestions would be greatly apprciated.
> Jorge Garcia
> 1965 BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as britcrs@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|