healeys
[Top] [All Lists]

Re: [Healeys] Brake Hoses ---

To: "Graham and Lorraine Wilkie" <glwilkie@bigpond.com>,
Subject: Re: [Healeys] Brake Hoses ---
From: "Earl Kagna" <kags@shaw.ca>
Date: Sat, 23 May 2009 09:53:24 -0700
Graham:

Thanks - this info helps greatly!  As it now develops, we will be pulling 
the flexible hoses off of a friends BJ8 in the next few days - we're pretty 
sure that the hoses are original (believe it of not).

If it turns out that there is any substantial difference in the 
measurements, I will post to the list.  I believe from what I have here, 
that your measurments are correct.

Thanks again,  ---------  Earl

----- Original Message ----- 
From: "Graham and Lorraine Wilkie" <glwilkie@bigpond.com>
To: "Earl Kagna" <kags@shaw.ca>; <healeys@autox.team.net>
Sent: Friday, May 22, 2009 9:30 PM
Subject: Re: [Healeys] Brake Hoses ---


Hi Earl,

Assuming that Moss sent me the correct BJ8 hydraulic flexible hoses
(these are new and not yet installed), their lengths are as follows:

2 front brake flexible hoses (each):  13 1/8"  (333mm).
Rear (axle) brake flexible hose: 12 9/16"  (320mm).
Clutch flexible hose:  9 3/4"  (248mm).

I hope that helps you figure out what you have there.

Cheers, Graham Wilkie.
HBJ8L / 32382

Earl Kagna wrote:
> Fellow Listers:
>
> Anyone happen to know the correct lengths of the flexible hydraulic hoses 
> on
> a BJ8?  (earlier sixes should be the same).  I have a bunch lying around 
> and
> I'm trying to figure out what their applications are.  (TR6 hoses are 
> pretty
> close as I recall).  This would include the 2 front calliper hoses, the 
> rear
> axle hose, as well as the clutch slave hose.
>
> Thanks in advance.
>
> Earl Kagna
> Victoria, B.C.
> BT7 tri-carb
> BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>