healeys
[Top] [All Lists]

Re: [Healeys] caliper rebuild

To: Alan Seigrist <healey.nut@gmail.com>
Subject: Re: [Healeys] caliper rebuild
From: Oudesluys <coudesluijs@chello.nl>
Date: Sun, 27 Sep 2009 18:06:11 +0200
Alan,
However the calliper is cast iron and can corrode as wel to the point 
that the SS-piston will stick.
Kees Oudesluijs


Alan Seigrist schreef:
> Kees -
>
> You're right about the corrosion, but George bought SS pistons so it 
> shouldn't be an issue.  The old chrome plated ones would go, but the 
> SS ones are much better.
>
> Alan
>
> '52 A90
> '53 BN1
> '64 BJ8
>
>
> On Sun, Sep 27, 2009 at 3:34 PM, Oudesluys <coudesluijs@chello.nl 
> <mailto:coudesluijs@chello.nl>> wrote:
>
>     When assembling brake cilinders or callipers use the special
>     lubricant only. If you use brake fluid this will also remain on
>     the exposed outside parts which can cause future corrosion.
>     I always use Ate. But Girling, Lockheed and others all have their
>     own version. One tube will last you forever. I think I have used
>     the same tube for over 40 years. The same stuff is still
>     available. It has the consistency of liquid soap.
>     Also check that you have the right seals. If these are slightly
>     oversized (wrong kit?) they will get damaged.
>     Kees Oudesluijs
>     NL
>
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.409 / Virus Database: 270.13.113/2397 - Release Date: 09/26/09 
>17:51:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>