healeys
[Top] [All Lists]

[Healeys] Fw: body panel fit

To: "Healeys" <healeys@autox.team.net>
Subject: [Healeys] Fw: body panel fit
From: "Rich C" <richchrysler@quickclic.net>
Date: Sat, 26 Dec 2009 12:57:30 -0500
> Hello Simon,
>
> Please see answers below interspersed with your questions...........
>
>> Need some advice.
>>
>> Have my chassis rolling with all brake lines and electrical done, dash
>> installed and gas tank in.
>
>> Question 1:
>> Has anyone had any experience test fitting body panels while adding 
>> weight
>> to simulate the engine/trans in place? How much weight did you add?
> If  (I repeat "IF") your chassis structure is in good condition you 
> shouldn't have to preload things. It should only flex an amount measurable 
> in thousandths of an inch
>
> Question 2:
> What's the best way to strip 2 coats of paint off the panels? Should this 
> be
>> done after all repairs so you can immediately prime and paint after?
> You can do this yourself by hand but it's a lot of time consuming labour. 
> We always have the panels dip stripped and immediately sprayed with a self 
> etching prmer if we can't get to the repairing portion of the work right 
> away. All the repairs are done thereafter. However, all these panel 
> repairs should have been done before any of the chassis assembly work 
> began. You may well have to get into chassis repair work to get all the 
> body panels to fit properly.

Rich Chrysler 
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>
  • [Healeys] Fw: body panel fit, Rich C <=