healeys
[Top] [All Lists]

Re: [Healeys] Wire wheel truing

To: "'Healey List'" <healeys@autox.team.net>
Subject: Re: [Healeys] Wire wheel truing
From: "BJ8 Healeys" <sbyers@ec.rr.com>
Date: Fri, 28 Jan 2011 08:24:50 -0500
Gergo, I still have my notes from a technical session given by a Dayton wire
wheel representative at Conclave 1986.  The notes say that 0,030 inch is the
best runout achievable on a new wheel.  That is 0,762 mm, so you're pretty
close.
 
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC  USA
 
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Austin Healey
Sent: Friday, January 28, 2011 7:35 AM
To: Healey List
Subject: [Healeys] Wire wheel truing
 
Hi,

I have dismantled my wheels.
I have made an attempt rebuilding one. It was not that hard as I thouht.
Although I have two questions: first of all, what can be called "true"
shape? After an hour playing, I have resulted around 0,8mm off-shape. Is it
enough, or shall I go thurder? It is difficult to use a dial gauge as he rim
itself is not 100% round.
I have tried to span each spoke the same amount, though not sure of this
"amount". I have used an aprox 10-12cms spanner with a medium load. Each
spoke is ringing alike.

What do You think, is it ok?

Gergo
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/sbyers@ec.rr.com 
  _____  

No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1204 / Virus Database: 1435/3406 - Release Date: 01/27/11
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>