healeys
[Top] [All Lists]

Re: [Healeys] BJ8 Carburetor Throttle Shaft

To: WILLIAM B LAWRENCE <ynotink@msn.com>
Subject: Re: [Healeys] BJ8 Carburetor Throttle Shaft
From: John Harper <ah@jharper.demon.co.uk>
Date: Sun, 6 Feb 2011 09:06:49 +0000
I am wondering if other have the same experience. Admittedly on A-H 100 
and early models, I have found that these shaft pins are actually 
tapered. Being so they will only come out easily in the way they were 
fitted. Replacement shaft kits recently purchased from Burlen called up 
taper pins in there instruction sheet but they only supplied straight 
pins. Perhaps there is some sense in this because not many owners will 
have a set of taper reamers. Luckily I have and put the pins back as 
original. A plain pin will work I suspect but is rather a compromise.

Regards

>Drill the holes to match the original position otherwise your linkage will not
>line up.
>Bill Lawrence
>
>> I am in the process of rebuilding my carburetors and have ordered some new
>> parts. One is the throttle shaft. The replacement is much longer than the
>> original and does not have holes for the pins at the end.
John Harper
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>