I used a small block of wood, something hard like oak. It should be
long enough so that when
rested against the end of the stub axel it stick out beyond the end of
the hub but short enough so
that you can start the knock-off on the threads of the hub. Tighten
the knock-off and the hub should
come loose.
HTH,
Peter Schauss
1963 BJ7
1980 MGB
On Tue, Aug 9, 2011 at 12:29 PM, R. Price Lindsay <rplindsay@comcast.net> wrote:
> Over the weekend the front left bearings went out (lots of noise metal
> shavings). I have removed the castle nut and rotor bolts but cannot get the
> hub off. It wiggles but won't pull off. The book says to use a hub extractor.
> Is this necessary or can I use a lever of some kind?
>
> Price Lindsay
> 67 BJ8
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|