Re: [Healeys] Steering column outer tube replacment - help

[john spaur <jmsdarch@sbcglobal.net>]

Richard,

It is not difficult at all. However, if you plan on powder coating 
the box and tube or even if not, use silver solder because it has a 
higher melting point. The higher the better because regular solder 
and powder coating are done at about 400 degrees F. Don't get things 
too hot, keep everything clean and use lots of flux.

John

At 02:29 AM 12/15/2011 +0000, richard mayor wrote:
>I need some advise about replacing a damaged outer steering column tube. ...
>
>Richard Mayor
>BN7L-466  Vintage Racer
>Portland, Oregon
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys




http://www.team.net/archive