Can't help on dimensions, but here's some info:
http://www.mossmotors.com/graphics/products/PDF/021-511.pdf
Bob
--------------------------------
Bob Spidell - San Jose, CA
----- Original Message -----
Hi all,
I found the old discussion thread below while surfing for info on the
angle drive for a BJ8.
I have a new one on order since mine failed last week.
Does anyone know the dimension of the washer mentioned, thickness of
course most important?
I want to know if I don't receive one with my order.
Thanks, Peter Ehn
PS.
My drive "crashed" last week, and I think I actually reset the trip
meter while driving as someone mentioned in the old thread. Don't know
if this was the cause, but speedo and cable are OK and easy to spin by
hand.
Peter Ehn
AH 3000 MKIII, 1967. BJ8 42208.
Bromma/Stockholm, Sweden
Phone: +46 708 33 72 97
E-mail: peter.ehn at frontwalker.se <mailto:peter.ehn at frontwalker.se>
|