Ken,
The packing plate goes on the shut face side but they go between the aluminum
door finisher and the shut face pillar I'm pretty sure. If I remember
correctly I used a few choice expletives while getting the proper alignment and
fit.
Hope this helps,
George Haywood
'65 bj8
---- goldengt at cal.net wrote:
> On the BJ8 parts list, a packing plate for the door striker is shown but not
> exactly. Should this packing plate be on the shut face side where it could
> help move the striker in and out for an adjustment or should the plate be in
> the fender well next to the threaded plate? Per my old parts I need to start
> bending the reproduction stuff. Sticking the packing plate against the shut
> face would help.Thanks,Ken Freese65 BJ8Note to Len- thanks for the picture,
> but that is not the part that is worn on my car.
|