healeys
[Top] [All Lists]

[Healeys] BJ8 Windshield Replacement

Subject: [Healeys] BJ8 Windshield Replacement
From: bspidell at comcast.net (Bob Spidell)
Date: Sat, 8 Apr 2017 15:29:41 -0700
References: <edbb4145-7bf1-0292-973d-2ac18f217bd7@comcast.net> <EEA6D680AF934C8A9B152D4CC53DC033@CharliePC>
Now I'm confused ... it looks like the glass should just slide out of 
the inner frame; you're saying I have to remove the whole 
kit-and-kaboodle, including the outer frame and frame-to-shroud seal?

Bob


On 4/8/2017 3:18 PM, Charlie Schott wrote:
> I've done it on a BJ8 and a BT7 windshield and it's not hard to do. 
> Make sure that you have good corner brackets and the right length 
> screws. The hardest part is pulling the lower seal thru the T slot. 
> Use plenty of liquid dishwater soap and grab the end with vice grips 
> to pull it.
>
> Regards,
>
> Charlie Schott
>
> -----Original Message----- From: Bob Spidell
> Sent: Saturday, April 08, 2017 1:51 PM
> To: Healeys
> Subject: [Healeys] BJ8 Windshield Replacement
>
> Listers,
>
> Anyone replaced the windshield--just the glass and enclosing seal--on a
> BJ8?  I have new glass, would order the seal kit from Moss (part#
> 682-028), and have a 'pro' do the installation (unless this is easy
> enough for a ham-fisted DIYer).  I don't want to pull the whole
> thing--wind wings and all--just the 'main' glass. Anybody done this, or
> is it best to let the pro do it?
>
> TIA,
> Bob
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/healeys/schottc at knology.net
>


<Prev in Thread] Current Thread [Next in Thread>