healeys
[Top] [All Lists]

[Healeys] cable

Subject: [Healeys] cable
From: phoenix722 at comcast.net (Mike S)
Date: Mon, 29 May 2017 10:39:42 -0700
References: <20170529072128.GB2D6.16325.root@pamxwww02-z01>
Well, the cable is in one piece, and looks ok, still a nice square on 
both ends.  I will pull the right angle drive. Question.  If I remove 
the drive, will all the oil run out?  I hope not.

Mike


On 5/29/2017 4:21 AM, Tom Felts wrote:
> if it turns easily from the top, either the cable is broken---the cable is to 
> short--or the other end of the cable has rounded out---or lastly--the right 
> angle drive is broken.  Pull it all out and inspect all pieces.
>
> tom
> ---- Mike S <phoenix722 at comcast.net> wrote:
>
> =============
> Interestingly, the speedo was working fine, until one day it didn't.  No
> warning.  I decided to unhook the connection at the back of the speedo
> and see if the square end of the cable was rotatable.  To my surprise,
> the entire cable was not even connected to the speedometer.  Just
> hanging loose.  Since it takes quite a few turns to screw it on, this
> seems odd. Connecting it did not solve the problem. Anyway, the cable
> itself turns quite easily; does this mean the cable itself is broken?
> If so, I will have to pull each end out separately.  It's a real pain to
> get under the car, as it is an inch off the ground (it seems), and I am
> more than an inch thick.  Working from the top as Bob suggested sounds
> better.
>
> Mike
>
>
> On 5/28/2017 7:18 PM, John Spaur wrote:
>> Not sure what it takes to get to the back of the speedo but on my BT7 I
>> unscrew the cable housing and pull out the cable. A new one can be slipped
>> in if the housing is good.
>>
>> John
>> '62 BT7
>>
>> -----Original Message-----
>> From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob
>> England
>> Sent: Sunday, May 28, 2017 5:07 PM
>> To: 'Healey List'<healeys at autox.team.net>
>> Subject: Re: [Healeys] cable
>>
>> Finally a question I can help with!  As a new Healy owner I've been lurking
>> on the list for the past few weeks, soaking up the questions and answers as
>> best a new Healy owner can.
>>
>> Answer to your question Mike : from above.  Definitely.  Take the seats out,
>> remove the radio console and transmission tunnel, and all is exposed.  Did
>> this earlier today on our BJ8 to replace a missing engine/bell housing bolt
>> and did not take too long at all.
>>
>> Bob
>>
>> -----Original Message-----
>> From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Mike S
>> Sent: May 28, 2017 5:00 PM
>> To: Healey List
>> Subject: [Healeys] cable
>>
>> Any hints on replacing the speedometer cable on my BJ8?  From above or
>> below.....?
>>
>> --
>> Mike
>>
>>
>>

-- 
Mike

MGTD (long gone)
BN1 (long gone)
BN2-100M (gone but in good hands)
BJ8

<Prev in Thread] Current Thread [Next in Thread>