Give it a tap whilst holding it up.
John Rowe
Qld
Australia
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Michael
MacLean
Sent: Sunday, 17 September 2017 9:00 AM
To: jmsdarch at sbcglobal.net; 'Healey List'
Subject: Re: [Healeys] Rear Axle Slave Cyl
Yes, I am prying it up, but it does not move easily. When I pry it up there is
pressure on the wheel cylinder making it difficult to slide out. Heck, it's
been in there 61 years.
Mike MacLean
Sent from Yahoo Mail on Android
<https://overview.mail.yahoo.com/mobile/?.src=Android>
On Sat, Sep 16, 2017 at 2:54 PM, John Spaur
<jmsdarch at sbcglobal.net> wrote:
One of the plates has two lock tabs on the end. I think it is the plate facing
down. You need to pry it up and then it will slide off.
John Spaur
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Michael
MacLean
Sent: Saturday, September 16, 2017 11:05 AM
To: Healey List <healeys at autox.team.net>
Subject: [Healeys] Rear Axle Slave Cyl
Is there a way to remove the rear axle brake cylinder without destroying the
two plates that lock together to hold it to the backplate?
Mike MacLean
Sent from Yahoo Mail on Android
<https://overview.mail.yahoo.com/mobile/?.src=Android>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170917/211f7404/attachment.html>
|